From Locked Up RC:
Our 1.9″ Bonesaw Ring Inserts are a good way so as to add a little bit of coloration to your Locked Up RC wheel set.
Like our standard “Backlight Glow Rings”, these inserts are sandwiched between your present bead lock ring and wheel.
These Ring Inserts protrude from behind your ring to supply a numerous quantity of coloration relying on setup.
With extra enamel than you’ll be able to rely (OK, it’s 40) these inserts are sharp…. pun supposed.
These inserts can be utilized with ANY of our 1.9″ bead lock rings however we really feel they appear greatest with our extra open designs just like the Agile, Demon & Sever.
What is included:
- 1x 1.9″ Bonesaw Bubble Gum Ring Insert
Specs:
FDM printed with PLA
Matte Finish
41mm outer diameter
Printed elements might require you to do some closing deburring. Just like plastic elements from a elements tree.
So, BEFORE set up, please verify the piece for any burrs that must be eliminated.
To set up:
1. Remove your outer bead lock ring and lay your wheel face up.
2. Place the Insert Ring into the wheel in order that the aspect with the “flange” is on the high.
3. Reattach the bead lock ring and tighten to softly push insert into place.
4. Verify that the bead lock ring is flush in opposition to the wheel (verify from the perimeters).
(If the ring shouldn’t be sitting flush, verify for alignment and burrs.)
#2103-BubbleGum – $3.00
Visit LockedUpRC.com
See more posts about Locked Up RC
